23
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switch
3. Tighten the screws with a No. 1 Phillips screwdriver to secure each bracket.
4. Align the mounting holes in the brackets with the holes in the rack, and insert two pan-head
screws with nylon washers through each bracket and into the rack.
5. T
ighten the screws with a No. 2 Phillips screwdriver to secure mounting brackets to the rack.
Figure 10. Rack mount
Step 3: Check the Installation
Before applying power to the switch, perform the following steps:
• Inspect the equipment thoroughly
.
• V
erify that all cables are installed correctly.
• Check cable routing to make sure that cables are not damaged or creating a safety
hazard.
• Ensure that all equipment is mounted properly and securely
.
To Next Page
Loading...
