Specify Network Settings
110
AC1750 Smart WiFi Router
The user name is admin. The user name and password are case-sensitive.
The BASIC Home page displays.
4. Select ADV
ANCED > Setup > LAN Setup.
5. In the IP Address field, type the IP address.
6. In the IP Subnet Mask field, type the subnet mask of the router.
The IP address and subnet mask identify which addresses are local to a specific device
and which must be reached through a gateway or router.
7. Change the RIP settings.
Router Information Protocol (RIP) allows a router to exchange routing information with
other routers.
a. In the RIP Direction menu, select one of the following:
- Both.
The router broadcasts its routing table periodically and incorporates
information that it receives.
- Out Only.
The router broadcasts its routing table periodically.
- In Only.
The router incorporates the RIP information that it receives.
b. In the RIP V
ersion menu, select one of the following:
- Disabled.
This is the default setting.
- RIP-1.
This format is universally supported. It is adequate for most networks,
unless your network setup is unusual.
- RIP-2.
This format carries more information. Both RIP-2B and RIP-2M send the
routing data in RIP-2 format. RIP-2B uses subnet broadcasting. RIP-2M uses
multicasting.
8. Click the Apply button.
Your changes are saved.
To Next Page
Loading...
Need help?
General
