NETGEAR R6400v2 User Manual

Hardware Setup
13
AC1750 Smart WiFi Router
Cable Your Router
The following image shows how to cable your router:
Figure 4. Router cabling
 To cable your router:
1. Unplug your modem’
s power, leaving the modem connected to the wall jack for your
Internet service.
If your modem uses a battery backup, remove the battery.
2. Plug in and turn on your modem.
If your modem uses a battery backup, replace the battery.
3. Connect your modem to the Internet port of your router with the yellow Ethernet cable that
came with your router.
4. Connect the power adapter to your router and plug the power adapter into an outlet.
5. Press the Power On/Off button on the rear panel of the router.

NETGEAR R6400v2 Specifications

General

WiFi Performance	AC1750 (450 + 1300 Mbps)
USB Ports	1 x USB 3.0
Antenna	3 external antennas
Beamforming	Yes
MU-MIMO	Yes
Parental Controls	Yes
Quality of Service (QoS)	Yes
WiFi Technology	802.11ac
Processor	Dual Core
Ethernet Ports	5 x 10/100/1000 Mbps Gigabit Ethernet ports (1 WAN & 4 LAN)
Security	WPA/WPA2
Dimensions	11.22 x 7.26 x 1.97 inches