NETGEAR R6400v2 User Manual

Specify Network Settings
126
AC1750 Smart WiFi Router
Use the Router as a Wireless Access Point
You can set up the router to run as an access point (AP) on the same local network as
another router or gateway.
 To set up the router as an AP after you set up your Internet:
1. Use an Ethernet cable to connect the Internet port of this router to a LAN port on your
existing router or gateway
.
Cable this port to a LAN port
on another router
2. Launch an Internet browser from a computer or mobile device that is connected to the
network.
3. T
ype http://www.routerlogin.net or http://www.routerlogin.com.
A login window opens.
4. Enter the router user name and password.
The user name is admin.
The user name and password are case-sensitive.
The BASIC Home page displays.
5. Select ADV
ANCED > Advanced Setup > Wireless AP.
6. Select the Enable AP Mode check box.
7. Scroll down and select an IP address setting:

NETGEAR R6400v2 Specifications

General

WiFi Performance	AC1750 (450 + 1300 Mbps)
USB Ports	1 x USB 3.0
Antenna	3 external antennas
Beamforming	Yes
MU-MIMO	Yes
Parental Controls	Yes
Quality of Service (QoS)	Yes
WiFi Technology	802.11ac
Processor	Dual Core
Ethernet Ports	5 x 10/100/1000 Mbps Gigabit Ethernet ports (1 WAN & 4 LAN)
Security	WPA/WPA2
Dimensions	11.22 x 7.26 x 1.97 inches