NETGEAR R6400v2 User Manual

Troubleshooting
174
AC1750 Smart WiFi Router
your computer Network Control Panel. Verify that the IP address of the router is listed as
the default gateway.
• Check to see that the network address of your computer (the portion of the IP address
specified by the subnet mask) is different from the network address of the remote device.
• Check that your cable or DSL modem is connected and functioning.
• If your ISP assigned a host name to your computer, enter that host name as the account
name in the Internet Setup page.
• Your ISP might be rejecting the Ethernet MAC addresses of all but one of your
computers.
Many broadband ISPs restrict access by allowing traffic only from the MAC address of
your broadband modem. Some ISPs additionally restrict access to the MAC address of a
single computer connected to that modem. If your ISP does this, configure your router to
“clone” or “spoof” the MAC address from the authorized computer.

NETGEAR R6400v2 Specifications

General

WiFi Performance	AC1750 (450 + 1300 Mbps)
USB Ports	1 x USB 3.0
Antenna	3 external antennas
Beamforming	Yes
MU-MIMO	Yes
Parental Controls	Yes
Quality of Service (QoS)	Yes
WiFi Technology	802.11ac
Processor	Dual Core
Ethernet Ports	5 x 10/100/1000 Mbps Gigabit Ethernet ports (1 WAN & 4 LAN)
Security	WPA/WPA2
Dimensions	11.22 x 7.26 x 1.97 inches