Figure 3. Rear panel
Viewed from left to right, the back panel contains the following components:
• LED On/Off button. If this button is pressed, all the modem router's LEDs are turned off except the
Power LED.
• SIM slot. Insert a micro-SIM card into this slot.
• Reset button. Pressing the Reset button returns the modem router to its factory settings. For information
about the factory settings, see Factory Settings on page 176.
• Ethernet ports. ports. Four Gigabit Ethernet RJ-45 LAN ports to connect the modem router to LAN
devices.
• Internet port. One Gigabit Ethernet RJ-45 WAN port to connect the modem router to a cable modem.
• USB port. One USB 2.0 port to connect a storage device.
• Power On/Off button. Press the Power On/Off button to provide power to the modem router.
• DC power connector. Connect the power adapter that came in the product package to the DC power
connector.
Hardware Setup
12
Nighthawk AC1900 WiFi LTE Modem Router
To Next Page
Loading...
