Installation Guide for the NETGEAR 108 Mbps Wireless PCI Adapter WG311T
2-6 Basic Setup
Configure your WG311T.
a. Click the icon in the Windows
system tray to open the WG311T Smart
Wireless Settings Utility.
The utility opens to the Settings tab
page.
b. Change the Network Name SSID to
match your network.
Tip: As an alternative to typing in the
SSID, you can use the drop-down list or
the Networks tab to view the available
wireless networks, and choose the one
you want.
c. Click Apply to activate the connection.
You can also enter a profile name and
click Save Profile to store the current
settings.
Windows XP Network Connection Alert
Note: This procedure assumes your wireless network
is not using WEP security. If your wireless network
uses WEP, set up your WG311T accordingly. To view
WEP settings help, click the Advanced button and
click the “Learn about...” link on the Windows XP Local
Area Connection Wireless Networks Properties tab
page.
WG311T Configuration Utility
Note: The NETGEAR default settings are
Infrastructure mode, with ANY for the wireless
network name SSID, and WEP disabled.
Right-click here to display this menu.
To Next Page
Loading...
Need help?
General
