User Manual for the NETGEAR 108 Mbps Wireless PCI Adapter WG311T
3-4
v4.0, February 2006
2. Now, install the wireless PCI adapter.
a. Shut down your computer and unplug
the power cord.
b. Open the case and insert your WG311T
into a PCI slot.
c. Connect the antenna to the adapter and
position the antenna to the up position.
d. Close the case, plug the power cord
back in, and restart your computer.
Figure 3-2
3. Use the Smart Wizard to set up your
wireless PCI adapter.
a. Choose to set up your wireless adapter
either with the NETGEAR Smart
Wizard (recommended) or the Windows
configuration utility
If you choose the Windows Zero
Configuration option, then you must
read the Windows XP documentation
for instructions.
Figure 3-3
b. Click Next to accept the NETGEAR
Smart Wizard.
You will be prompted to let the
wizard help you connect to a network
(recommended).
c. Click Next to accept.
Figure 3-4
To Next Page
Loading...
Need help?
General
