NETGEAR WG311T User Manual

User Manual for the NETGEAR 108 Mbps Wireless PCI Adapter WG311T
4-13
v4.0, February 2006
Setting up WPA-PSK Security
Follow the steps below to configure WPA-PSK Security.
1. Run the WG311T Smart Wizard.
a. Make sure the WG311T software is installed and the WG311T is properly installed in a
PCI slot in your computer.
b. Use the icon to open the Smart Wizard. The Settings tab page opens.
2. Configure the Security settings.
a. In the Profile box, select the profile or type in a profile name.
b. In the Network Name (SSID) field select the network, or enter the SSID.
c. In the Security section, select WPA-PSK [TKIP] and enter the passphrase. The passphrase
can be a word or a group of printable characters.
For more information on WPA security, see the Web link to “Wireless Communications:”
in Appendix B.
Figure 4-9
Note: You will not get a wireless network connection unless the network SSID
matches exactly what is configured in the access point.

NETGEAR WG311T Specifications

General

Brand	NETGEAR
Model	WG311T
Category	PCI Card
Language	English