User Manual for the NETGEAR 108 Mbps Wireless PCI Adapter WG311T
4-10
v4.0, February 2006
Setting up WEP Encryption Security
Follow the steps below to configure WEP Encryption Security.
1. Run the WG311T Smart Wizard.
a. Make sure the WG311T software is installed and the WG311T is installed in a PCI slot in
your computer.
2. Configure the Security settings.
a. In the Profile box, select the profile or type in a profile name.
b. In the Network Name (SSID) field select the network, or enter the SSID.
c. In the Security section, select WEP.
3. Select the WEP encryption strength you will use.
The choices are:
• 64-bit WEP data encryption
• 128-bit WEP data encryption
b. Use the icon to
open the Smart Wizard.
The Settings tab page
opens
Figure 4-7
Note: You will not get a wireless network connection unless the network SSID
matches exactly what is configured in the access point.
To Next Page
Loading...
Need help?
General
