User Manual for the NETGEAR 108 Mbps Wireless PCI Adapter WG311T
4-2
v4.0, February 2006
Finding a Network
During the WG311T software installation, the Smart Wizard lists the available networks. After
installation you can use the Find a Network button on the Network tab at any time to view the
available networks and select the one that you want to use.
Follow the steps below to Find a Network.
The Smart Wizard initiates your wireless connection. You can use the Status Bar to verify your
network connection. For more information, see “The Smart Wizard Status Bar” on page 3-9.
Note: Make sure that you know the security settings for the network that you want to use.
For example, if WEP is used then you need to know the WEP key. If you use secure
networks frequently, set up profiles for each network with the wireless network and
security settings.
1. Use the icon to open the
Smart Wizard.
The Settings tab page opens.
2. On the Networks tab page,
click Find a Network.
3. Select a network from the drop
down list. If you select a hidden
network then you must enter
the SSID. Click Next.
4. Follow the steps of the wizard
to specify the wireless security
if used, and to create a profile.
5. Review you settings, and click
Finish.
Figure 4-1
Hidden Network
To Next Page
Loading...
Need help?
General
