User Manual for the NETGEAR 108 Mbps Wireless PCI Adapter WG311T
4-6
v4.0, February 2006
3. Save your settings in a Profile.
a. Click the Save Profile button.
All the configuration settings are saved in this profile.
b. Click Apply.
c. Click Close to exit the Smart Wizard, or Cancel to return to the previous settings.
4. Configure the PC network settings.
a. Configure each PC with either a static IP address or with the IPX protocol.
b. Restart the PCs.
5. Verify wireless connectivity between your peer devices.
Verify connectivity by using the Ping program:
c. This will cause a continuous ping to be sent to the device with the 192.168.0.1 static IP
address. The ping response should change to “reply.”
Note: For instructions on configuring static IP addresses, refer to the networking
tutorial on your NETGEAR 108 Mbps Wireless PCI Adapter WG311T Resource CD.
a. On the Windows taskbar click the Start
button, and then click Run.
b. Assuming the target PC is configured
with 192.168.0.1 as its IP address, type
ping -t 192.168.0.1 and then click
OK.
Figure 4-4
Figure 4-5
To Next Page
Loading...
Need help?
General
