User Manual for the NETGEAR 108 Mbps Wireless PCI Adapter WG311T
4-15
v4.0, February 2006
The screen also shows the following information for each network scanned:
• Network Name (SSID): The name assigned to a wireless network. This is the same as the
SSID or ESSID configuration parameter. Note that as a security measure, some wireless
access points do not broadcast their SSID. In such cases, the SSID field will be blank even
though the rest of the information will still be displayed.
• Channel: The channel determines which operating frequency will be used.
• Security: Identifies whether the wireless network uses WEP or WPA-PSK security settings.
• Signal: Identifies the signal strength of the communications.
• MAC Address: Identifies the hardware address (MAC Address) of the wireless device
broadcasting this information.
• Mode: Identifies the type of wireless network — Access Point (Infrastructure) or Computer-
to-Computer (Ad Hoc).
The following buttons are at the bottom of
the Networks tab:
• Help: Display online help.
• Find a Network: Use the wizard to
help you connect to a network. See
“Finding a Network” on page 4-2.
• Connect: Connect to the network that
you selected.
• Scan: Check for wireless networks.
• Close: Close the window of the Wizard.
Figure 4-11
Note: You can click the Scan button to scan for networks and refresh the page.
To Next Page
Loading...
Need help?
General
