User Manual for the NETGEAR 54 Mbps Wireless PC Card WG511 v2
Configuring Wireless Adapter Settings 3-13
June 2005
2. Configure the Security settings.
a. In the Profile box, select the profile or type in a profile name.
b. In the Network Name (SSID) field select the network, or enter the SSID.
Note: You will not get a wireless network connection unless the network SSID matches
exactly what is configured in the access point.
c. In the Security section, select WPA-PSK.
d. Select either TKIP or AES. For more information on WPA security, see “WPA Wireless
Security” on page B-8.
3. Save your settings in a Profile.
a. Click the Save Profile button. All the configuration settings are saved in this profile.
b. Click Apply.
c. Click Close to exit the configuration utility.
Advanced Settings Button
The Advanced Settings should normally work in their default settings. On the Settings tab click the
Advanced Settings button to display the dialog box shown below.
Figure 3-7: Advanced Settings
To Next Page
Loading...
