User Manual for the NETGEAR 54 Mbps Wireless PC Card WG511 v2
Basic Setup 2-3
June 2005
Your NETGEAR 54 Mbps Wireless PC Card WG511 v2 factory default basic settings are:
• Network Name Service Set Identification (SSID): Any (First available network)
Note: In order for the WG511 v2 Wireless PC Card to communicate with a wireless access
point or wireless adapter, all devices must be configured with the same wireless network name
(SSID).
• Network Mode (Infrastructure or Ad-hoc): Infrastructure
• Data security WEP or WPA-PSK encryption: Disabled
The section below provides instructions for setting up the NETGEAR 54 Mbps Wireless PC Card
WG511 v2 for basic wireless connectivity to an access point. The procedures below provide
step-by-step installation instructions for Windows PCs. Use the procedure that corresponds to the
version of Windows you are using.
Basic Installation Instructions
Use the procedure below that corresponds to the version of Windows you are using.
For Windows XP Users Installing a WG511 v2
1. First, install the WG511 v2 software.
a. Insert the NETGEAR CD.
If the CD main
page does not appear, double click
autorun.exe on the CD.
b. Click the Install Driver & Utility link and
the Smart Wizard starts.
c. Follow the Wizard steps and click Next to
continue.
To Next Page
Loading...
