NETGEAR WGT624 User Manual

Reference Manual for the 108 Mbps Wireless Firewall Router WGT624 v3
Configuring the Internet and Wireless Settings 3-9
202-10090-01, April 2005
Usually, select Use Default MAC Address.
If your ISP requires MAC authentication, then select either Use Computer MAC address to
disguise the Router's MAC address with the Computer's own MAC address or Use This MAC
Address to manually type the MAC address for a different computer. The format for the MAC
address is XX:XX:XX:XX:XX:XX. This value may be changed if the Use Computer MAC
Address is selected once a value has already been set in the Use This MAC Address selection.
Click Test to connect to the NETGEAR Web site. If you connect successfully, your settings work
and you may click Logout to exit these pages and... enjoy surfing the 'net!
If you don't connect successfully,
1. Go through the settings and make sure you've selected the correct options and typed
everything correctly.
2. Contact your ISP to verify the configuration information.
3. Read the Troubleshooting section in the Router Installation Guide.
4. On the Router GearBox CD, read the Troubleshooting Guide or the Troubleshooting section in
the Reference Manual.
5. Contact NETGEAR Technical Support.

NETGEAR WGT624 Specifications

General

Wireless Standard	802.11g
Frequency Band	2.4 GHz
LAN Ports	4 x 10/100 Mbps
WAN Port	1 x 10/100 Mbps
Standards	IEEE 802.11g, IEEE 802.11b, IEEE 802.3, IEEE 802.3u
Wireless Data Rates	Up to 54 Mbps
Security	WPA, WEP
Firewall	SPI Firewall
Weight	270 g