EasyManuals Logo

NETGEAR WGT624 User Manual

NETGEAR WGT624
148 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #57 background imageLoading...
Page #57 background image
Reference Manual for the 108 Mbps Wireless Firewall Router WGT624 v3
Advanced Configuration 6-7
202-10090-01, April 2005
Configuring WAN Setup Options
The WAN Setup options let you configure a DMZ server, change the MTU size and enable the
wireless router to respond to a Ping on the WAN port. These options are discussed below.
Figure 6-3: WAN Setup menu.
Connect Automatically, as Required
Normally, this option should be enabled. An Internet connection will be made automatically
after each timeout, whenever Internet-bound traffic is detected. This provides connection on
demand and is potentially cost-saving.
If disabled, you must connect manually, using the Connection Status button on the Router
Status screen. This manual connection will stay up all the time without timeouts.
Disable SPI Firewall
Normally, this option should be Enabled, so that your local network will be protected by the
Stateful Packet Inspection (SPI) firewall included in the WGT624 v3. However, certain
communications functions like VPN may require turning off the SPI feature.
Note: When SPI Firewall is disabled, you must use the Passive mode in the PC FTP
client to connect to the FTP server.

Table of Contents

Other manuals for NETGEAR WGT624

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR WGT624 and is the answer not in the manual?

NETGEAR WGT624 Specifications

General IconGeneral
Wireless Standard802.11g
Frequency Band2.4 GHz
LAN Ports4 x 10/100 Mbps
WAN Port1 x 10/100 Mbps
StandardsIEEE 802.11g, IEEE 802.11b, IEEE 802.3, IEEE 802.3u
Wireless Data RatesUp to 54 Mbps
SecurityWPA, WEP
FirewallSPI Firewall
Weight270 g

Related product manuals