EasyManuals Logo

NETGEAR WGT624 User Manual

NETGEAR WGT624
148 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #76 background imageLoading...
Page #76 background image
Reference Manual for the 108 Mbps Wireless Firewall Router WGT624 v3
7-6 Troubleshooting
202-10090-01, April 2005
If the path is working, you see this message:
Reply from < IP address >: bytes=32 time=NN ms TTL=xxx
If the path is not working, you see this message:
Request timed out
If the path is not functioning correctly, you could have one of the following problems:
Wrong physical connections
Make sure the LAN port LED is on. If the LED is off, follow the instructions in
“Local or Internet Port LEDs Not On” on page 7-2.
Check that the corresponding Link LEDs are on for your network interface card and
for the hub ports (if any) that are connected to your workstation and router.
Wrong network configuration
Verify that the Ethernet card driver software and TCP/IP software are both installed
and configured on your PC or workstation.
Verify that the IP address for your router and your workstation are correct and that the
addresses are on the same subnet.
Testing the Path from Your PC to a Remote Device
After verifying that the LAN path works correctly, test the path from your PC to a remote device.
From the Windows run menu, type:
PING -n 10 <IP address>
where <IP address> is the IP address of a remote device such as your ISP’s DNS server.
If the path is functioning correctly, replies as in the previous section are displayed. If you do not
receive replies:
Check that your PC has the IP address of your router listed as the default gateway. If the IP
configuration of your PC is assigned by DHCP, this information will not be visible in your
PC’s Network Control Panel. Verify that the IP address of the router is listed as the default
gateway as described in “Verifying TCP/IP Properties” on page C-6.
Check to see that the network address of your PC (the portion of the IP address specified
by the netmask) is different from the network address of the remote device.
Check that your cable or DSL modem is connected and functioning.

Table of Contents

Other manuals for NETGEAR WGT624

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR WGT624 and is the answer not in the manual?

NETGEAR WGT624 Specifications

General IconGeneral
Wireless Standard802.11g
Frequency Band2.4 GHz
LAN Ports4 x 10/100 Mbps
WAN Port1 x 10/100 Mbps
StandardsIEEE 802.11g, IEEE 802.11b, IEEE 802.3, IEEE 802.3u
Wireless Data RatesUp to 54 Mbps
SecurityWPA, WEP
FirewallSPI Firewall
Weight270 g

Related product manuals