Reference Manual for the 108 Mbps Wireless Firewall Router WGT624 v3
3-12 Configuring the Internet and Wireless Settings
202-10090-01, April 2005
• Encryption Strength: Select the WEP Encryption level:
64-bit (sometimes called 40-bit) encryption
128-bit encryption
• Security Encryption (WEP) Key: If WEP is enabled, you can manually or
automatically program the four data encryption keys. These values must be identical
on all PCs and Access Points in your network.
• Automatic Key Generation (Passphrase): Enter a word or group of printable
characters in the Passphrase box and click the Generate button to automatically
configure the WEP Key(s). If encryption strength is set to 64 bit, then each of the four
key boxes will automatically be populated with key values. If encryption strength is
set to 128 bit, then only the selected WEP key box will automatically be populated
with key values.
• Manual Entry Mode: Select which of the four keys will be used and enter the
matching WEP key information for your network in the selected key box.
For 64 bit WEP: Enter ten hexadecimal digits (any combination of 0-9, A-F).
For 128 bit WEP: Enter twenty-six hexadecimal digits (any combination of 0-9, A-F).
– WPA-PSK (Wi-Fi Protected Access Pre-Shared Key): use WPA-PSK standard
encryption
• Security Encryption (WPA-PSK): Enter a word or group of printable characters in
the Passphrase box. The Passphrase must be 8 to 63 characters in length.
To Next Page
Loading...
Need help?
General
