Need help?Do you have a question about the NETGEAR WNCE2001 - Ethernet to Wireless Adapter and is the answer not in the manual?
Overview of the Internet adapter's physical components, including top and rear panels and LEDs.
Details on powering the adapter using electrical outlets or USB ports.
Step-by-step instructions for initial setup and connecting the adapter.
Procedures for reconnecting the adapter to a computer for configuration changes.
Guide to configuring the adapter by selecting a wireless network and applying security.
Screen displaying current hardware, firmware, and wireless connection status.
View performance metrics like packet transmission and utilization for LAN/WLAN.
Information on the adapter's IP address, subnet mask, gateway, and lease.
Options to set IP address dynamically from router or use a static IP.
Save, restore, or erase adapter configuration settings.
Instructions on how to check for and install new firmware for the adapter.
Adjust fragmentation length, CTS/RTS threshold, and preamble mode.
Using Push 'N' Connect or PIN method to connect to wireless networks.
Solutions for issues like the power LED being red or intermittent resets.
Steps to resolve browser errors or connection issues with the adapter's interface.
Guidance on troubleshooting failures to connect to a wireless network.
Procedure to restore the adapter to its default factory configuration.
Details on antenna, data rate, frequency, power, emissions, and encryption.
List of links to external documents for further technical information.
Information on FCC, Canadian, EU compliance, and RF exposure guidelines.
To Next Page
General