16 | Chapter 2. Advanced Settings
Universal WiFi Internet Adapter WNCE2001
Advanced Wireless Settings
CAUTION:
The Internet adapter is already configured with the optimum settings. Do
not alter these settings unless directed by NETGEAR support. Incorrect
settings might degrade the wireless performance of the Internet adapter.
To view or change the advanced wireless settings:
From the Internet adapter menu at http://www.mywifiext.net, under the Advanced heading,
select Wireless Settings. The following screen displays
You can view or configure the following settings:
• Fragmentation Length (256-2346): This is the maximum packet size used for
fragmentation. Packets larger than the size programmed in this field are fragmented.
• CTS/RTS Threshold (1-2347): The packet size that is used to determine whether it
should use the CSMA/CA (Carrier Sense Multiple Access with Collision Avoidance)
mechanism for wireless packet transmission.
• Preamble Mode. An Auto setting might give slightly better performance. A Long setting
might provide a more reliable connection or slightly longer range.
Using Push 'N' Connect (WPS)
WPS (WiFi Protected Setup) lets you connect to a wireless network without entering its
passphrase or wireless key. Instead, you use a button or enter a PIN to connect.
If you have a NETGEAR router, this feature is called Push ‘N’ Connect. Look for the or
symbol on the router to make sure the NETGEAR router supports WPS. For
non-NETGEAR routers, refer to the user manual to determine if the router supports WPS.
Note: The Universal WiFi Internet Adapter (WNCE2001) Installation Guide
explains how to use WPS during installation.
To Next Page
Loading...
Need help?
General
