EasyManuals Logo

NETGEAR WNDR3400v2 User Manual

NETGEAR WNDR3400v2
122 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #103 background imageLoading...
Page #103 background image
Troubleshooting
103
N600 Wireless Dual Band Router WNDR3400v2
If all LEDs are still on 1 minute after power-up:
Cycle the power to see if the router recovers.
Press and hold the Restore Factory Settings button to return the router to its factory
settings. See Factory Settings on page 110.
If the error persists, you might have a hardware problem and should contact technical
support at www.netgear.com/support.
Internet or Ethernet Port LEDs Are Off
If either the Ethernet port LEDs or the Internet LED does not light when the Ethernet
connection is made, check the following:
Make sure that the Ethernet cable connections are secure at the router and at the modem
or computer.
Make sure that power is turned on to the connected modem or computer.
Be sure that you are using the correct cable:
When connecting the router’s Internet port to a cable or DSL modem, use the cable that
was supplied with the cable or DSL modem. This cable could be a standard
straight-through Ethernet cable or an Ethernet crossover cable.
Wireless LEDs Are Off
If the Wireless LEDs stay off, check to see if the Wireless On/Off button on the router has
been pressed. This button turns the wireless radios in the router on and off. The Wireless
LEDs are lit when the wireless radio is turned on.
The Push 'N' Connect (WPS) Button Blinks Amber
If after using the WPS function the button blinks amber, check the following:
Make sure that you are using the button and not the router’s built-in registrar.
Check that PIN verification has succeeded for the wireless device you are adding to the
wireless network.
Make sure you have not pressed the WPS button on the top of the router after disabling
the WPS feature (you logged in to the router and disabled this previously).
Check that the router is not in the temporary AP setup locked state (if you are using the
wireless repeater function).
Cannot Log In to the Router
If you are unable to log in to the router from a computer on your local network, check the
following:

Table of Contents

Other manuals for NETGEAR WNDR3400v2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR WNDR3400v2 and is the answer not in the manual?

NETGEAR WNDR3400v2 Specifications

General IconGeneral
BrandNETGEAR
ModelWNDR3400v2
WiFi RangeMedium to large homes
Wireless Standard802.11a/b/g/n
Frequency Band2.4 GHz and 5 GHz
USB Ports1 x USB 2.0
WiFi SpeedUp to 300 Mbps (2.4 GHz) + 300 Mbps (5 GHz)
Ethernet Ports4 x 10/100 Mbps
Security FeaturesWPA/WPA2
Firewall FeaturesSPI, NAT
AntennaInternal antennas
Weight0.7 lb (0.32 kg)

Related product manuals