Chapter 2. Powerline Utility | 19
Powerline AV+ 200 Adapter Kit XAVB1501
3. To set the traffic prioritization rule into the selected adapter device, specify the priority in the
QoS Setup section of the screen.
4. Click Apply.
Note: QoS settings are applied only to the device that is selected on the
QoS tab.
These options only apply to QoS-configured business networks. IEEE 802.1p uses
prioritization bits in Layer-2 frames. Type of Service routing (ToS) uses prioritization bits in
Layer-3 IP packets. The deprecated ToS values range from 0 to 7.
To Next Page
Loading...
Need help?
General