Netio 230C - Control and Configuration; Output Control; Port Parameter Configuration

9
5. Control and configuration
5.1. Control and configuration of the outputs
5.1.1. Control of outputs
In the left section of the window, click Manual Control. The page containing the controls of the individual outputs
is displayed.
Figure 5.1. Manual control of the outputs
NETIO-230C/CS can control all the four outputs simultaneously. Select the port, which should be activated or
deactivated and click Apply. If you only want to restart the device connected to the given port, select the field
Interrupt and click Apply. The port is deactivated for the period set in the menu Status & configuration in the
field Interrupt delay and then restarted. Short-term interruption of the port can be used only on an active port.
If you want to manually activate/deactivate the given output, or restart it, check whether the port´s Manual field
is selected. If the field is not selected, the device does not accept the manual commands and functions in time
switching and watchdog mode. The button All off is used to switch off all the active outputs.
5.1.2. Configuration of port parameters
Click Status & configuration in the left part of the window and a list of ports and information about their actual
state appears in the window on the right side.