Control and configuration
14
Device name: in this field, you can name your device for easier identification later. When
DHCP hostname send is selected, this value is sent to the DHCP server.
Firmware version: only informative in character and shows the actual firmware version.
If you edit this page, click Apply and the device changes the network parameters and automatically restarts. After
restart, you must login again. The button Reset To Default is used to reset the device to factory settings.
5.2.2. E-mail configuration
After clicking Setup e-mail, a form is displayed in the right side for setting of the e-mail.
Figure 5.5. E-mail configuration
From: this address shall be shown in the message as the sender´s address.
To: the message shall be sent to this address.
SMTP server: mail server, via which the message shall be sent.
Message subject: used to enter the subject of the sent message. Enter the text that should be displayed
upon sending the e-mail message.
Click Apply to save the settings. The button Send test message is used to send a test message.
Note: The current firmware version does not support SMTP authorisation.
5.2.3. Time settings
Click Date & time in the menu to display the form for setting time in the right section.
The NETIO-230C/CS supports three time setting methods. You enter the time, either manually or using the SNTP
server for automatic time synchronisation, or time synchronisation with the local computer.
To Next Page
Loading...
