Netio 230C - Serial Tunnel (Model NETIO-230 CS)

Control and configuration
15
Figure 5.6. Setting the date and time
SNTP enable: activation of synchronisation with the SNTP server
SNTP status: displays the synchronisation state
Synchronized: time synchronised with SNTP server
Not Synchronized: synchronisation with SNTP server not done
Local time offset: manual setting of time zone - time offset in minutes
Daylight saving time: Activation of summer time
Daylight saving time start: date and time of summer time start
Daylight saving time end: date and time of summer time end
Local time: manual setting of local time with deactivated synchronisation with SNTP
server
Setting of the summer time and local time offset applies to both automatic setting and setting via SNTP. If you do not
set Local Time Offset during synchronisation of time with the SNTP server, the default GMT 0 zone shall be used.
5.2.4. Serial tunnel (model NETIO-230CS)
In the case of the NETIO-230CS model, you can use the serial tunnel function for remote control of additional
device via the serial link. Connect devices with serial link to the connector marked with the tunnel symbol on
the front panel.