Control and configuration
25
• Data format: 8N1
The command format is identical to that of the commands for communication via KSHELL interface. The list of
commands is in the following chapter.
Note: for communication via serial link, you do not need to login as applies to communication via KSHELL
interface. This means that after connection of the cable, you can directly enter the kshell commands to the
terminal.
5.3.6. Return values for KSHELL, CGI and serial link
100 HELLO <hash>
Device response after connection. Hash after HELLO can be used for encrypted login.
110 BYE
You have been logged off.
120 Rebooting....
Restarting
130 CONNECTION TIMEOUT
Connection time-out.
250 OK
Command executed successfully. The value returned by the called command may follow.
500 INVALID VALUE
Incorrectly entered value.
501 INVALID PARAMETER
Incorrectly entered parameter.
502 UNKNOWN COMMAND
Incorrectly entered or unknown command.
503 INVALID LOGIN
Incorrectly entered username or password.
504 ALREADY LOGGED IN
You are already logged in.
505 FORBIDDEN
You are not authorised to execute the given command. Log in as user with higher authorization.
506 INPUT LINE TOO LONG
To Next Page
Loading...
