Control and configuration
13
Figure 5.4. Configuration of the network
DHCP: DHCP on/off. When DHCP is off, it is possible to change the parameters
manually.
DHCP hostname send: enables sending of device name to DHCP server.
SNTP from DHCP: enables automatic setting of the server for synchronisation of time according
to the address set on the DHCP server.
Switch delay (x0.1s): determines the period between triggering two outputs. This delay is set to protect
the device from overload upon switching on all outputs simultaneously .
KSHELL Port, WEB Port: makes it possible to change the default port for access via telnet, or to the web
interface of the device.
CGI compatibility: activates the compatibility mode with CGI command format in preceding
NETIO-230A (up to fw v2.33) and NETIO-230B (up to fw v3.0) devices. The
compatibility mode does not permit input of multiple commands to one CGI.
Usage of the compatibility mode is not recommended for safety reasons.
To Next Page
Loading...
