43
Nets SmartPOS N950 user manual
3.2 Battery
The terminal is equipped with a battery. Please, follow the guidance below to maintain a healthy battery and battery life.
3.2.1 Charging the battery
Before using the terminal, charge the battery well. Place the terminal in
the charging base and keep the base connected to a power supply when
it is not being operated.
Alternatively, Insert the USB cable into the USB-C slot and connect the
power chords to a power supply.
Note!
Make sure that the terminal is switched o and that
the adapter is disconnected before installing the
battery. Always use the original battery and power
adapter provided by Nets. Using alternative batteries
or adapters from dierent devices or providers may
cause damage, heating, or even explosion in the
hardware and battery. Charge the terminal under the
conditions described in this document.
Please follow the guidance below for battery installation. Improper installation will harm the battery.
Disassembling the battery:
Reverse the above-described steps.
1. Turn the terminal
upside down and open
the battery cover.
2. Insert the battery plug
into the socket and insert
the battery into the
battery compartment.
3. Once the battery
is installed, press the
battery cable to make
the cable lower than the
battery.
4. Close the battery
cover.
To Next Page
Loading...