IP Address: When you enter the Reflector screen,
the LR G2 automatically obtains and displays its IP
address in the top field. Use this IP address to
connect to the LR G2 from your main
performance testing device.
MAC Address: LinkRunner G2's MAC address
Packet Type: Touch the down caret to select
the packet type filter setting. The MAC +
NETSCOUT setting tells LR G2 to reflect only
packets with a destination MAC address that
matches the LR G2's own MAC address and
NETSCOUT payload.
Swap: Touch the down caret to select a swap
setting. MAC + IP tells the LR G2 to swap the
source and destination MAC and IP addresses for
packets that are reflected back to LR G2.
NOTE: The recommended settings are Packet
Type: MAC + NETSCOUT and Swap: MAC + IP.
Other Reflector settings may cause undesired
traffic on your network.
81
Additional Features
To Next Page
Loading...
