(2)
Firmware Version:
Firmware version will be displayed by scanning “$SW#VER”.
Connection Way
Scanner can be connected to your device via bluetooth, USB receiver or USB cable, you can
choose one of the connection way to connect scanner with your device.
$SW#VER
Barcode Programming
Netum barcode scanners are factory programmed for the most common terminal and
communications settings. If you need to change these settings, programming is
accomplished by scanning the bar codes in this guide. An asterisk (*) next to an option
indicates the default setting.
Important Notes :
Many command barcodes only work with scanner in a particular connection mode. Please
pay attention to below symbol when you scanning the command barcodes.
Command barcodes only apply to scanner work via Bluetooth connection.
Command bacodes only apply to scanner work via Wireless Connection.
Command bacodes only apply to scanner work via USB Wired Connection
Working Via USB Cable
Get Started: Connect scanner with your device via USB cable. If you use US keyboard, it's
plug and play. If you use other type of keyboard , please refer to "keyboard language" to
con�igure the keyboard language before you use it.
To Next Page
Loading...
Need help?
General
