7
Press TIME ON
To start the main time.
Press TIME OFF
to stop the main time.
NOTE: The Time On and Time Off keys may also control other timers in the configuration.
NOTE: The Time On and Time Off keys are disabled if the hand held time control switch is plugged in to
the control.
NOTE: To make these two keys active again, turn the control power off, disconnect the hand held time
control switch, and restart the control. You may use “
START WHERE TURNED OFF
LAST
”, if you wish.
Press TIME
to recall the main time to the display. If other timers are in use, successive key presses will toggle
among the main time and the other timers.
Press SET TIME
to enter the Time and Period setting mode. The control will prompt
[__SET__MM:SS.s_____]
Enter the Minutes, Seconds, and Tenth Second as needed. Press YES to accept the time
entered.
NOTE: Letters that have not been replaced with numbers will be replaced with
zeros.
NOTE:
Pressing NO will allow you to back up to make corrections or to abort without changing
the time.
The control will prompt
[___PERIOD______0___]
Enter the Period number or press NO to exit without changing the current data.
Press HOME SCORE
to enter the home score ADD mode.
The control might prompt
[__HOME_______25+__]
. In this example the current Home Score
is 25 and the “+” indicates that the control is ready to add to the current score. Enter a single digit number
or press NO or YES or another function key to abort and leave the score unchanged.
NOTE: You cannot subtract from a score. To correct a mistake use the SET key, then the HOME or
GUEST SCORE key and directly enter the correct score (up to 199).
GUEST SCORE
works the same way.
Home
Score
Guest
Score
Time
Time
On
Time
Off
To Next Page
