33
OSC[ ]?
Set and query the synthesizer frequency.
The OSC command sets and queries the internal synthesizer. In INT Sync
mode setting the synthesizer frequency will set the chopping frequency. In
INT Sync mode the data supplied by the OSC command is limited by the
chopper wheel minimum and maximum chopping frequencies. In the other
modes of operation, the data may range from 4.00 to 99.9 kHz.
Only three digits of resolution are available. The data is entered in Hz, and no
decimal point should be included.
OSC54300 (Sets the internal synthesizer to 543 Hz.)
OSC?
OSC543.00
Command
Description
Explanation
Example
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...