Newco LCD-TCH - Programming QR Codes for Operation; Enabling Touchless and Combined Modes

21
Programming QR Codes
FOR “TOUCH AND COMBINED”
OPERATIONS:
TAP 3 TIMES ON CENTER OF THE
“L”
THEN TAP 3 TIMES ON CENTER OF
THE “D”
TO ENTER SECONDARY
PROGRAMMING MODE
IF A BREWING ICON IS
ACCIDENTLY TOUCHED USE THE
RETURN ARROW TO TRY AGAIN.
FOR “TOUCHLESS” ONLY
OPERATION:
TAP 3 TIMES IN TOP LEFT
CORNER.
THEN TAP 3 TIMES ON BOTTOM
RIGHT CORNER.
TO ENTER LOWER-LEVEL
PROGRAMMING: TAP 3 TIMES ON
BOTTOM RIGHT CORNER.
PRESS “SETUP”
“TOUCHLESS” MODE IS OFF.
TOUCH SCREEN OPERATION
ONLY. QR NOT AVAILABLE.
“TOUCHLESS” MODE IS ON.
TOUCHLESS OPERATION ONLY.
QR READY.
“TOUCHLESS COMBINED MODE IS ON.
TOUCH SCREEN & TOUCHLESS
OPERATIONS AVAILABLE . QR READY.
PRESS THE “TOUCHLESS” BUTTON
TO HIGHLIGHT EITHER “OFF”, “ON”,
OR “COMBINED”. PRESS THE “+” OR
“-“ TO CHANGE MODES.