Product Installation Procedure
Open product box and remove the BIB outlet, Fig. 1. Remove
cardboard circle and seat coffee outlet in box cutout as shown
in Fig. 2.
Remove the plastic insert from the BIB fitment as and attach
product fitting shown in Fig 3. Using finger and thumb only to
prevent over-tightening, thread the BIB connector on to the
BIB fitment until it is fully seated .
Place the product in the storage compartment as shown in
Fig.4.
Repeat installation for 2
nd
product and position boxes and
hoses as shown in Fig. 5. Note: Regular Coffee BIB is
installed on the LH side of the product compartment and
Decaf Coffee BIB is installed on the RH side of the product
compartment
Fig. 1
Fig. 2
Fig. 4
Fig. 3
Fig. 5
Regular
Decaf
To Next Page
Loading...
