CONEX-AGAP Agilis-D Controller with Strain Gages Feedback
1.6 Connect and Authorize your Newport Instruments
Before to connect your Newport instrument, read the manual to install its
communication driver. Once the communication driver installed, the Newport
instrument can be connected to the computer.
Once NSTRUCT installed and NSTRUCT server is running, the instrument can be
connected and detected by the NSTRUCT server only if it is “plug and play”.
If the Newport instrument cannot be detected automatically, open the NSTRUCT
server to add this instrument to the server. To do that, refer you to the video “How to
add an instrument” from NSTRUCT help or refer you to the applet manual of the
selected instrument.
The connected instrument is now detected by the NSTRUCT server after a
“Rediscover instruments” action. The first time, the instrument is “Unauthorized”. In
this case, open the NSTRUCT server, click right on your selected instrument and
choose “Authorize”.
At the end, the selected instrument must be connected, detected and authorized by the
NSTRUCT server.
EDH0293En1020 — 09/12 Page 2
To Next Page
Loading...
