December 2019 96 LDC-3706 Series Laser Controller
Error Code Explanation
-343 The limit calibration has failed.
-344 A calibration memory write error has occurred.
-345 A calibration memory read error has occurred.
-350 A queue overflow has occurred.
-360 General communications error.
-410 Query interrupted.
-420 Query unterminated.
-430 Query deadlock.
402 Temperature sensor open error.
403 TEC open circuit error.
407 TEC temperature limit error.
412 General TEC programming error.
501 Laser interlock error.
503 Laser open circuit error.
504 Laser over current error.
509 Laser temperature out of range error.
596 Unknown laser board detected.
597 Laser over power.
To Next Page
Loading...
