Newport LDC-3706 Series - Page 66

December 2019 54 LDC-3706 Series Laser Controller
Table 4.1 – Remote Command Summary of IEEE 488.1 Common Commands
COMMAND SYNTA
X
FUNCTION
*CLS
Resets the Standard Event Register, Status Byte and Error Queue to zero.
*ESE <integer>
Sets the Standard Event Status Enable Register.
*ESE?
Returns the value of the Standard Event Status Enable Register.
*ESR?
Returns the value of the Standard Event Status Register.
*IDN?
Returns the Device Identification string.
*OPC
Generates the Operation Complete message in the Standard Event Status Register.
*OPC?
Places an ASCII character 1 into the Output Queue.
*RCL <integer>
Used to recall a stored setup configuration.
*RST
Forces a device reset.
*SAV <integer>
Saves the current setup configuration.
*SRE <integer>
Sets the Service Request Enable Register bits to allow generation of use
r
-selectable service requests.
*SRE?
Returns the current contents of the Service Request Enable Register.
*STB?
Returns the current contents of the Status Byte Register.
*WAI
Prevents executing any further commands until the No-Operation-Pending flag is true.