Newport New Focus Picomotor 8742 - Using Ethernet Routers;Switchers; Connecting Three Units to a Computer Via an Ethernet Router

36 Initial Setup
4.7.2 Using Ethernet Routers/Switchers
If several 8742 units need to be controlled via Ethernet, connect them to a router at
the LAN (Local Area Network) ports. The router will assign an IP address to each
8742 Controller/Driver. Connect a computer to the same router at one LAN port.
Use the Picomotor Application provided on the USB Flash Drive to discover and
establish a connection to each 8742 unit.
Connecting three units to a computer via an Ethernet
router