Peak 650 User's Guide Rev. A October 2000
BIOS Setup
4-19
Init Display First
This item allows you to decide to active whether PCI Slot or on-chip VGA first
The Choice: PCI Slot, Onboard.
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector read/write. If your IDE
hard drive supports block mode (most new drives do), select Enabled for automatic detection of the
optimal number of block read/writes per sector the drive can support.
The Choice: Enabled, Disabled
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the system board and you
wish to use it. If you install add-on FDC Controller Card or the system has no floppy drive, select
Disabled in this field.
The Choice: Enabled, Disabled.
Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first and second serial ports.
The Choice: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
UART Mode Select
This item allows you to select UART mode.
The Choice: Normal, .IrDA, ASKIR
UR2 Duplex Mode
This item allows you to select the IR half/full duplex function.
The Choice: Half, Full.
Onboard Parallel Port
This item allows you to determine access On-Board parallel port controller with which I/O address.
The Choice: 3BC/IRQ7, 378/IRQ7, 278/IRQ5, Disabled.
Parallel Port Mode
Select an operating mode for the On-Board parallel (printer) port. Select
Normal, Compatible,
or
SPP
unless you are certain your hardware and software both support one of the other available modes.
The Choice: SPP, EPP, ECP, ECP+EPP.
To Next Page
Loading...
