NXAMPMK2 USER MANUAL PAGE 51 / 80
ENERGY SAVER ENABLED
When enabled, the amplifier goes to Energy Saver Mode when no input signal has been received during a
given time interval. The power consumption is then reduced. When input signal is received again, the
amplifier leaves the Energy Save Mode.
No-signal time interval can be adjusted from 1 minute to 3 hours.
No-signal threshold level can be adjusted from -70 dBFS to 60 dBFS.
By default, Energy Saver Mode is disabled.
Energy saving measurements are available in Thermal Dissipation and Current Draw section.
DPU MODE
See DPU Digital Patching Unit for NXAMP section.
DEVICE INFORMATION
Displays some numeric information about the unit like Serial Number, Firmware, Main, Boot and Boot2
revision.
To Next Page
Loading...
