IN VEHICLE INSTALLATION
1. Insert a suitable memory card in to the iN-CAR CAM, taking care to follow correct orientation
markings (gold contacts facing the back of the device). Push the memory card until it clicks into
place.
Note:
- Do not remove or insert the memory card when the iN-CAR CAM is turned on. This may
damage the memory card.
- Use the edge of a small coin (or similar object) to push the memory card in place if required.
Take care that card has ‘clicked’ into place, a second push inwards will release the memory
card.
2. Attach the iN-CAR CAM to the supplied window GPS mount, taking care the locking tab has
‘clicked’ firmly into place.
3. Remove the protective plastic film from the suction pad. Select the required position for the
windscreen mount and clean windscreen with a dry / clean cloth to achieve good contact
between the glass and mount.
While holding the suction cup onto the glass rotate the locking dial clockwise to secure the
mount to the windscreen.
Please ensure that once mounted the iN-CAR CAM is located within the area of the vehicles
windscreen wipers to maintain a clear view during rainfall.
Note:
Choose a smooth glass area without painted effect.
Please follow the instructions below for correct installation of the iN-CAR CAM.
12-24V DC
The above diagram is for illustration purposes only.
12
To Next Page
Loading...
Need help?
General
Weight and Dimensions
