nextys DCW20 - Wizard Configuration Utility; Technical Specifications

DCW20 User Manual rev. 5
Page 34/34
4.4.2.21 Warning over temperature
LCD name
Modbus address
Warn. over temperature
0x403A
Value1
Value2
Inactive (0), Active (1)
Not used
Active when the internal temperature is high. If the temperature increases more the device may switch
OFF.
4.4.2.22 Error over temperature
LCD name
Modbus address
Error over temperature
0x403B
Value1
Value2
Inactive (0), Active (1)
Not used
Active when the internal temperature is too high. To prevent damage the device switches OFF.
4.4.3 Events
4.4.3.1 Power ON event
LCD name
Modbus address
Power ON
0xE000
Value1
Value2
Power ON count
Not used
Generated at every time the DCW20 is turned ON.
4.4.3.2 Shutdown event
LCD name
Modbus address
Shutdown
0xE001
Value1
Value2
Shutdown count
Shutdown reason:
1 - Deep discharge
2 - Max. backup time elapsed
3 - Shutdown command
4 - Reset command
5 - Inhibit signal
Generated at every time the DCW20 is turned OFF.
4.5 Wizard
The wizard assists the user during the DCW20 configuration. It should be run once at commissioning.
5 Technical Specifications
See DCW20 datasheet available on www.nextys.com.
DCW20_040-02-700-005-EH-1117