X.COM3 - MOTORCYCLE BLUETOOTH COMMUNICATION SYSTEM WITH MESH INTERCOM
29
7.5 ENABLE/DISABLE MIC (DEFAULT: ENABLE)
Users can enable/disable the microphone when communicating in a Mesh
Intercom.
1s
HOLD
“Mic on” or “Mic off”
7.6 TOGGLING OPEN MESH/GROUP MESH
Users are able to toggle between Open Mesh and Group Mesh without
resetting the Mesh. This allows users to keep the Group Mesh Network
connection information while in Open Mesh.
Users can toggle to Group Mesh to communicate with participants from the
stored Group Mesh Network connection information.
Toggle Between Open Mesh and Group Mesh
3s
HOLD
“Open Mesh”
Open Mesh
“Group Mesh”
Group Mesh
Note: If you have never participated in Group Mesh, you cannot toggle
between Open Mesh and Group Mesh. You will hear a voice prompt,
“No group available.”
7.7 MESH REACH-OUT REQUEST
You (caller) can send a request message to turn on the Mesh Intercom to
nearby* friends who have it turned off.
1. If you want to send or receive a request message, you need to enable
Mesh Reach-Out on the Sena Motorcycles App. Please refer to
Section 13.2: “Software Conguration Setting.”
To Next Page
Loading...