X.COM3 - MOTORCYCLE BLUETOOTH COMMUNICATION SYSTEM WITH MESH INTERCOM
54
13.2.16 Voice Prompt (Default: Enable)
While some Voice Prompts may be disabled in the software conguration
settings, the following voice prompts are always on:
- Battery level indicator
- Speed dial
- FM radio functions
- Mesh Intercom
13.2.17 RDS AF Setting (Default: Disable)
A radio station with more than one frequency can be used by enabling
the Radio Data System (RDS) Alternative Frequency (AF) Setting. This
setting allows a receiver to re-tune to the second frequency location when
the rst signal becomes too weak.
13.2.18 FM Station Guide (Default: Enable)
When FM Station Guide is enabled, FM station frequencies are given by
voice prompts as you select preset stations.
13.2.19 Advanced Noise Control™ (Default: Enable)
When Advanced Noise Control is enabled, the background noise
is reduced during an intercom conversation. When it is disabled, the
background noise is mixed with your voice during intercom.
13.2.20 Region Selection
When using the region setting, you can optimize the seek function to
avoid unnecessary frequency ranges, allowing you to select the proper FM
frequency range for your location.
Region Frequency range Step
Worldwide 76.0 ~ 108.0 MHz ± 100 kHz
North America,
South America and Australia
87.5 ~ 107.9 MHz ± 200 kHz
Asia and Europe 87.5 ~ 108.0 MHz ± 100 kHz
Japan 76.0 ~ 95.0 MHz ± 100 kHz
To Next Page
Loading...