32
Setting the Stimulation Level
Getting started
Once the electrodes are placed and before walking with the stimulator the
output level must be set.
Turn on the ODFS
®
Pace (XL) by pressing and holding down the control
knob.
Press the test button. Observe that the indicator light ashes. You may
feel the sensation of stimulation. While the indicator light is ashing,
increase the output level by turning the control knob clockwise. Increase
the output level until the correct movement is achieved. If the movement is
incorrect, check the electrode positions.
Electrode positions
Clinician: please mark electrode positions on the appropriate
diagrams below:
Right Leg
3
To Next Page
Loading...