NHS ODFS Pace V1 - Electrodes and Electrode Care

35
Electrodes and Electrode Care
Odstock Medical Limited recommend the use of 50mm x 50mm self adhesive square
electrodes supplied within the ODFS
®
Pace (XL) boxed kits. These electrodes have proved
to be the most reliable in clinical practice, are the easiest to use and the least likely to cause
skin irritation. An alternative electrode type is the PALS
®
Plus range, available in a variety of
sizes suitable for other applications as well as dropped foot. ODFS
®
Pace (XL) users (such
as paediatric users) with smaller legs may require smaller electrodes.
Whichever type of electrodes are used, it is very important that both the skin and electrodes
are kept clean and in good condition. This will help prevent skin irritation developing.
If the skin is very dry, or if moisturiser has been used, wash the skin with warm water and
dry it before placing the electrodes on the skin. If moisturisers are required, use water based
products and apply at night before going to bed.
Do not place electrodes over broken skin or a rash of any kind.
Do not shave the skin as this may cause many tiny abrasions. If long hairs prevent
reliable skin adhesion, trim the hairs with scissors or a beard trimmer.
All electrodes are for single person use.
An elasticated tubular bandage (supplied in the kit) can be used to hold the
electrodes and leads in place.
Follow the instructions provided with the electrodes.
Electrode use and daily care
1. Connect the electrodes to the wires by sliding the pin into the connector on the electrodes.
Ensure that the pin is inserted fully and that no metal is visible.
2. Peel the electrode away from the plastic backing by lifting at the electrodes edge. Do not
pull the electrode’s lead.
3. Place the electrodes on the skin as described in the electrode placement section. Care
should be taken when putting on clothing over the electrodes and wires.
4. After use, ensure that the ODFS
®
Pace (XL) is turned o󰀨 before removing the electrodes.
Peel the electrode away from the skin by lifting it at the edge. Do not pull the lead. Return
the electrodes to the plastic backing. The leads can be left connected. Store the electrodes
in the packaging provided ensuring that they are sealed to prevent them drying out.
3