34 NIBE F1330
Installation / Adjustment
Description of functions - Expansion card 11
Description of functions - Expansion card 11
Electrical additional heater
To connect the relays ETS-4 to ETS-6, see the section
Description of functions - Basic functions > Electrical
additional heater.
HPAC
To connect HPAC on Expansion card 11 see the section
Description of functions - Basic functions > HPAC.
Access to the following functions requires
the Expansion card 11 (10) accessory with
associated terminal block X6A.
When this is connected the card
must be activated in menu 9.1.1.
NOTE!
LEK
10
X6a
The heat pump in the picture is fitted with accessories.
To Next Page
Loading...
Need help?
General
