Nibe F1330 - Setting the Heating Controls Setting Using Diagrams

7NIBE F1330
User guide
Setting the heating controls
Setting using diagrams
The heating control system of the F1330 is controlled by
the outside temperature. This means the flow temperature
is regulated in relation to the current outdoor temperature.
The relation between the outdoor temperature and flow
temperature is set in menu 2.1, Curve slope.
The diagram is based on the dimensioned outdoor tem-
perature in the area and the dimensioned supply tempera-
ture of the heating system. When these two values meet,
the heating control’s curve slope can be read.
The Heating curve offset knob is then set on the Master
unit. A suitable value for underfloor heating is -1 and for
a radiator system -2.
Heating
curve offset
Offset heating curve -2
15 14 13 12 11 10
9
8
7
6
5
4
3
2
1
- 40
UTETEMPERATUR
- 10
0
10
- 5
+ 5
30
40
50
60
70
FRAMLEDNINGSTEMPERATUR
- 20 - 30
FÖRSKJUTNING
VÄRMEKURVA (
-
2)
VÄRMEKURVA
HEATING CURVE
OFFSET HEATING
CURVE
SUPPLY TEMPERATURE
OUTSIDE
TEMPERATURE
Offset heating curve 0
30
40
50
60
70
FRAMLEDNINGSTEMPERATUR
- 40
UTETEMPERATUR
- 10
0
10
- 20 - 30
15 14 13 12 11 10 9
8
7
6
5
4
3
2
1
VÄRMEKURVA
- 5
+ 5
FÖRSKJUTNING
VÄRMEKURVA (0)
HEATING CURVE
OFFSET HEATING
CURVE
SUPPLY TEMPERATURE
OUTSIDE
TEMPERATURE
151413 12 11 10
8
7
6
5
4
3
2
1
- 40
UTETEMPERATUR
- 10
0
10
- 5
+ 5
30
40
50
60
70
FRAMLEDNINGSTEMPERATUR
- 20 - 30
FÖRSKJUTNING
VÄRMEKURVA (+2)
9
VÄRMEKURVA
HEATING CURVE
SUPPLY TEMPERATURE
OUTSIDE
TEMPERATURE
OFFSET HEATING
CURVE
Offset heating curve +2
Setting the heating controls