37NIBE F1330
Installation / Adjustment
Description of functions - Expansion card 11
Quick guide - menu settings pool
Menu 9.1.5 Pool [S]
Here pool heating is set either On or Off. The factory set-
ting is Off.
Menu 6.5.1 Start temp. pool [U]
Here you select at which pool temperature on the sensor
(PTG) heating should start. The value is adjustable be-
tween 5 and 60 °C in increments of 0.5 °C. The factory
setting is 22.0 °C.
Menu 6.5.2 Stop temp. pool [U]
Here you select at which pool temperature on the sen-
sor (PTG) heating should stop. Adjustable between 5 and
60 °C in increments of 0.5 °C. The factory setting
is 24.0 °C.
Menu 6.5.3 Periodtime heat/pool [U]
The length of time is set here. The value is adjustable
between 10 and 1000 minutes. The factory setting is
100 minutes.
Menu 6.5.4 Max-time heatproduct [U]
Here you select how much time of the period time (menu
6.5.3) is to be used to heat the house when there is a
need of heating and pool heating. The value is adjustable
between 0 and 1000 minutes. The factory setting is 50
minutes.
Menu 6.5.5 Max compr. to pool [U]
The maximum number of compressors that can be oper-
ated towards the pool exchanger (VX-P) is set here. The
number of compressors that currently produce pool heat
is within brackets. The value can be adjusted between 0
and 18. Factory setting is 1.
Menu 5.4.12 Pool heating compr. A [U]
The menu is only displayed when pool is selected as
“On” in menu 9.1.5
If it is “On”, compr. A in the heat pump that is selected
in menu 5.1 is permitted to carry out pool heating.
Menu 5.4.13 Pool heating compr. B [U]
The menu is only displayed when pool is selected as
“On” in menu 9.1.5
If it is “On”, compr. B in the heat pump that is selected
in menu 5.1 is permitted to carry out pool heating.
The outline diagram with docking instructions is
available at www.nibe.eu
To Next Page
Loading...
Need help?
General
